15204 Autoloader ALE: remove plate from conveyor or check sensor Platesetter_3244 Check conveyer plate sensor and cables. For S conveyer check fence. Check rollers operate. Lift lid of plate rotator and remove plate or push into processor, then Resume. This error is reported if there is still a plate sensed in the conveyer when shutting down the rollers after timing out: processor_infeed_delay (if processor interface enabled) + plate_process (error only reported if plate conveyer is enabled.) ../nvs/al_cal_npc.xmlNVS: al npc ../nvs/altim_cfg_plate.xmlNVS: altim plate ../nvs/aldly_cal_pid.xmlNVS: aldly pid ../commands/conveyer.xmlCommand: conveyer ../commands/processor.xmlCommand: processor ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:56 2008 PST